HyVista Corporation was contracted by DMITRE during August-September 2013 to process an archived set of HyMap airborne hyperspectral scanner data of the Earth's surface radiance properties, that had previously been acquired on 13/3/2002 from a survey window covering 117.8 sq km over a land corridor connecting the Spencer Gulf coastline to some mineral exploration licence ground held by Pima Mining NL in the Port Pirie region of the southern Flinders Ranges. The survey data had been acquired from 2 km altitude along four parallel flight lines in order to reconnoitre land usage and natural surface features which could impinge on a possible new road transport route to port for magnesite ore that was being considered for mining development as part of that company's SAMAG Project activities. The nominal pixel size acquired was 4.5 m x 4.5 m. DMITRE requested that this dataset be processed using HyVista's latest algorithms. The HyMap instrument is an airborne hyperspectral scanner delivering 126 separate radiance wavelength bands (approx 18 nm width per band) of imagery over the 450 nm to 2500 nm spectral interval. The spectral data acquisition system has been designed to operate in aircraft that have standard aerial photo-ports. The angular width of the recorded image is 61.3 degrees or about 2.3 km when operating 2000 m above ground level. Typically, the lateral spatial resolution of surface materials achieved with the instrument is in the range 3–10 m, dependent on the above-ground elevation of the aircraft. HyMap image data pre-processing is carried out on a survey flight line strip-by-strip basis, to produce radiance, apparent reflectance, and GLT (Geometric Lookup Table) files for later geometric rectification/mosaicing. The apparent reflectance images are corrected for cross-track and signal level (i.e. they are corrected for varying solar illumination). These reflectance images are then geo-corrected, to position each individual pixel in its accurate geo-location in the UTM/WGS 84 map projection. The corrected image data survey strips are then mosaiced to produce a seamless, homogeneous data (map) cube for the whole survey area (a map production step called 'Level 1C processing'). This data-cube is then processed further to produce the various Level 2 and 3 image products (Decorrelation Stretch RGB [red-green-blue], Mineral Map Multimineral Rule Classified, Mineral Map Ternary RGB, Mineral Maps Pseudocolour, Mineral Map Greyscale Threshold, MNF [Minimum Noise Fraction algorithm] Transform RGB, Overview Colour Composites (in both true and false colour), and Wavelength Mapping - Mineral Chemistry and Composition). The last type of processed image includes three separate products designed to depict either mica Al content, iron oxide composition or carbonate Mg/Ca ratio-composition.